Cisco ONS 15454 Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco ONS 15454. Cisco ONS 15454 22 stron. Four-shelf and zero-shelf bay assembly
Również dla Cisco ONS 15454: Instalacja (32 strony), Instalacja (32 strony), Rozpakowywanie i instalacja (42 strony), Rozpakowywanie i instalacja (40 strony)

Drukuj stronę

Chapter 2 Install Cards and Fiber-Optic Cable

Open the card latches/ejectors.

Step 2

Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the

Step 3

receptacle at the back of the slot.

Note

Step 4

Verify that the card is inserted correctly and close the latches/ejectors on the card.

Note

Step 5

Verify the LED activity:

•

Step 6

If the card does not boot up properly, or the LED activity does not mimic

•

Continue with the

Step 7

necessary.

Stop. You have completed this procedure.

NTP-A246 Install Ethernet Cards and Connectors

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

78-17697-01

If you install the wrong card in a slot, complete the

procedure on page

2-20.

It is possible to close the latches/ejectors when the card is not completely plugged into the

backplane. Ensure that you cannot insert the card any further.

The red FAIL LED turns on for 10 to 15 seconds.

The red FAIL LED blinks for 30 to 40 seconds.

All LEDs blink once and turn off for 1 to 5 seconds.

The ACT or ACT/STBY LED turns on. The SF LED can persist until all card ports connect to their

far-end counterparts and a signal is present.

If the red FAIL LED does not turn on, check the power.

If you insert a card into a slot provisioned for a different card, all LEDs turn off.

If the red FAIL LED is on continuously or the LEDs behave erratically, the card is not installed

properly. Remove the card and repeat Steps

"NTP-A246 Install Ethernet Cards and Connectors" procedure on page

This procedure describes how to install the Ethernet cards (E100T-12,

E100T-G, E1000-2, E1000-2-G, G1K-4, ML100T-12, ML1000-2,

ML100X-8, CE-100T-8, and CE-1000-4).

Ethernet cards

NTP-A15 Install the Common Control Cards, page 2-2

As needed

Onsite

None

NTP- A246 Install Ethernet Cards and Connectors

"NTP-A116 Remove and Replace a Card"

Step

to 5.

Cisco ONS 15454 Procedure Guide, R8.0

5, check the following:

2-11, if

2-11