Cisco Secure Network Server 3600 Series Instrukcja instalacji sprzętu - Strona 25

Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Serwer Cisco Secure Network Server 3600 Series. Cisco Secure Network Server 3600 Series 38 stron. Appliance

Drukuj stronę

1. Cisco Sns 3600 Series Appliance Hardware Specifications

Installing the Appliance

Step 3

Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab

and pivot the tab 180 degrees so that it points toward the rear of the appliance.

Figure 11: Reversing the CMA

CMA tab on end of width-adjustment slider

Initial Setup

Note

This section describes how to connect to the system for initial setup.

Appliance Default Settings

The appliance is shipped with the following default settings:

• The NIC mode is Shared LOM EXT.

• The NIC redundancy is Active-Active. All Ethernet ports are utilized simultaneously.

• DHCP is enabled.

• IPv4 is enabled.

Shared LOM EXT mode enables the 1-Gb/10-Gb Ethernet ports and the ports on any installed Cisco

virtual interface card (VIC) to access the Cisco IMC. If you want to use the 10/100/1000 dedicated

management ports to access Cisco IMC, you can change the NIC mode as described in

System With the Cisco IMC Configuration Utility, on page

Cisco Secure Network Server 3600 Series Appliance Hardware Installation Guide

Metal button on outside of tab

24.

Initial Setup

Setting Up the