Cisco UCS E Series Instrukcja instalacji - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Cisco UCS E Series. Cisco UCS E Series 46 stron. Ucs e series unified computing system
Również dla Cisco UCS E Series: Przegląd produktów (8 strony), Instrukcja rozwiązywania problemów (28 strony)
Drukuj stronę
The following warnings apply in Australia:
Warning
Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is OFF and the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected. Statement 4
This equipment will be inoperable when mains power fails. Statement 198
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Both
LAN and WAN ports may use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Hazardous network voltages are present in WAN ports regardless of whether power to the router is
Warning
OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first. Statement 1026
Before opening the chassis, disconnect the telephone-network cables to avoid contact with
Warning
telephone-network voltages. Statement 1041
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Installing the E-Series Servers
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning
Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF
or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables,
detach the end away from the unit first. Statement 1026
OL-26447-03
Hardware Installation Guide for Cisco UCS E-Series Servers
Installing the E-Series Servers
19