Cisco ASR 5000 Instrukcja instalacji - Strona 35

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Gateway Cisco ASR 5000. Cisco ASR 5000 37 stron. Applying power and verifying the installation
Również dla Cisco ASR 5000: Instrukcja instalacji (18 strony), Instrukcja instalacji (33 strony), Procedura instalacji (8 strony)

Drukuj stronę

Applying Power and Verifying the Installation

RCC Standby LED States

The Standby LED on the RCC indicates that software is loaded on the card. The card is ready to provide a

path for data or signalling traffic from a line card to a redundant packet processing card. This LED is on during

normal operation for both installed RCCs.

If the LED is not green, use the troubleshooting information in the table to diagnose the problem.

Table 31: RCC Standby LED States

Color

Green

None

Completing Initial System Configuration

After power is applied to the chassis and the ASR 5000 has successfully booted, the command line interface

(CLI) appears on a terminal connected to the Console port of the SPIO.

The initial configuration requires completing the following tasks via the CLI:

• Configuring the system for remote access

• Configuring the management interface with a second IP Address (optional)

• Configuring system timing

• Enabling CLI timestamping

• Configuring system administrative users

• Configuring TACACS+ for system administrative users (optional)

• Configuring a chassis key

• Configuring virtual MAC addresses

• Configuring packet processing and line card availability

• Configuring line card and SPIO port redundancy

• Configuring ASR 5000 link aggregation (optional)

• Configuring ORBEM and the Web Element Manager (optional)

Description

Troubleshooting

Card is in standby mode

This is the normal operating mode.

Card is not receiving

Verify that the Run/Fail LED is green. If so, the card is receiving

power OR

power and POST test results are positive. If it is off, refer to

Run/Fail LED States, on page 33

Card in Active Mode

Check the state of the Active LED. If it is green, the card is in

active mode and the RCC is actively routing traffic from a line

card installed behind a packet processing card that has failed. See

Checking the LEDs on Packet Processing Cards, on page 12

determine which packet processing card has failed.

Completing Initial System Configuration

for troubleshooting information.

ASR 5000 Installation Guide

RCC