Cisco MERAKI MR66 Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Gateway Cisco MERAKI MR66. Cisco MERAKI MR66 20 stron. Troubleshooting mesh communication between access points
Również dla Cisco MERAKI MR66: Podręcznik (7 strony)

Drukuj stronę

4. Plug the Ethernet cable into the Ethernet port of the Meraki MR66.

a. Connect the cable to the Ethernet port on the MR66.

b. Screw the gland body into the threaded hole of the port. Use an adjustable wrench to make sure the gland

body is fully seated in the hole.

c. Insert the split ring gasket into the gland body.

d. Screw the cap tightly onto the gland. You may need a wrench to fully tighten the cap, but take care not to

damage the cable in the process.

Attach Grounding Strap

Connect one end of grounding strap to grounding post with included screw and washer. Securely attach the other end

nearby metal structure.

Verify Device Functionality and Test Network Coverage

1. Check LEDs

The Radio Power LED should be solid green. If it is flashing orange, the firmware is automatically upgrading and

the LED should turn green when the upgrade is completed (normally in under thirty minutes). If the device is a

gateway, the Ethernet LED and the four Signal Strength LEDs should be green as well. If the device is a repeater

only, the Ethernet LED will not be illuminated and the number of green Signal Strength LEDs will show the signal

strength to the nearest Meraki device. See section 2.6 for further details about information conveyed by the LEDs.

Note: Your MR66 must have an active route to the Internet to check and upgrade its firmware.