Epson TM-L90 series Podręcznik produkcji - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik produkcji dla Akcesoria do drukarek Epson TM-L90 series. Epson TM-L90 series 22 stron. Attaching cover on the power switch
Również dla Epson TM-L90 series: Broszura (1 strony), Broszura (2 strony), Instrukcja obsługi produktu (27 strony), Specyfikacje (2 strony), Specyfikacje (8 strony), Podręcznik informacyjny (5 strony), Specyfikacje (4 strony), Podręcznik użytkownika (40 strony), Podręcznik użytkownika (17 strony), Podręcznik użytkownika (21 strony), Podręcznik użytkownika (21 strony), Zacznij tutaj (2 strony), Zacznij tutaj (2 strony), Podręcznik (13 strony), Instrukcja obsługi (12 strony), Podręcznik użytkownika (36 strony), Podręcznik rozwoju (34 strony), Podręcznik (2 strony)

Epson TM-L90 series Podręcznik produkcji
Confidential

3.8 Manual Paper Layout Setup

The manual paper layout setup is used to execute the "Paper layout setup" function by entering
paper data directly into the NV memory of the printer. This function enables adjusting the layout
more precisely than with the automatic paper layout setup. It is possible to set a paper type,
distance between marks, mark length, paper width, and items for printable area. After installing
the paper, do the paper layout setup.
Even if the transparency rates (refer to Section 3.9) differ between papers whose paper size is
the same (for example, when the backing paper changes from white glassine to blue), make sure
to do the paper layout setup.
There are two ways to use the "Manual paper layout setup." Refer to the appropriate instructions
for details.
• Use a memory switch setting utility. (Refer to the utility and its user's manual.)
• Control the printer directly with ESC/POS commands. (Refer to the ESC/POS Application
Programming Guide.)
3.9 Requirements for Transparency Rate of Die-Cut Label Paper
If die-cut label paper is used, the position of the label is determined by the difference between the
transparency of the label backing paper and the transparency of the backing paper only.
Therefore, it is recommended that you use label paper with a large difference of transparency. Be
sure the label meets the following requirements so that the printer can recognize the position of
the label.
NOTES: 1. Transparency rates are measured by the Macbeth TD-904 (with a filter for
infrared) photometer. The transparency rates are calculated as follows:
Use
Density = Log
Then,
Transparency rate (%) = (Amount of transparency / Amount of irradiation) × 100
(Amount of irradiation / Amount of transparency)
10
TITLE
TM-L90
Roll Paper
Manufacturing Guide
Label + Backing paper:
Transparency rate: 18% or less
Backing paper:
Transparency rate: 47% or more
SHEET
NO.
REVISION
A
NEXT
9
SHEET
8