Epson TM-L90 series Handleiding productie - Pagina 12

Blader online of download pdf Handleiding productie voor {categorie_naam} Epson TM-L90 series. Epson TM-L90 series 22 pagina's. Attaching cover on the power switch
Ook voor Epson TM-L90 series: Brochure (1 pagina's), Brochure (2 pagina's), Producthandleiding (27 pagina's), Specificaties (2 pagina's), Specificaties (8 pagina's), Informatie handleiding (5 pagina's), Specificaties (4 pagina's), Gebruikershandleiding (40 pagina's), Gebruikershandleiding (17 pagina's), Gebruikershandleiding (21 pagina's), Gebruikershandleiding (21 pagina's), Start Here (2 pagina's), Start Here (2 pagina's), Handmatig (13 pagina's), Gebruiksaanwijzing (12 pagina's), Gebruikershandleiding (36 pagina's), Ontwikkelingshandboek (34 pagina's), Handmatig (2 pagina's)

Confidential

3.8 Manual Paper Layout Setup

The manual paper layout setup is used to execute the "Paper layout setup" function by entering

paper data directly into the NV memory of the printer. This function enables adjusting the layout

more precisely than with the automatic paper layout setup. It is possible to set a paper type,

distance between marks, mark length, paper width, and items for printable area. After installing

the paper, do the paper layout setup.

Even if the transparency rates (refer to Section 3.9) differ between papers whose paper size is

the same (for example, when the backing paper changes from white glassine to blue), make sure

to do the paper layout setup.

There are two ways to use the "Manual paper layout setup." Refer to the appropriate instructions

for details.

• Use a memory switch setting utility. (Refer to the utility and its user's manual.)

• Control the printer directly with ESC/POS commands. (Refer to the ESC/POS Application

Programming Guide.)

3.9 Requirements for Transparency Rate of Die-Cut Label Paper

If die-cut label paper is used, the position of the label is determined by the difference between the

transparency of the label backing paper and the transparency of the backing paper only.

Therefore, it is recommended that you use label paper with a large difference of transparency. Be

sure the label meets the following requirements so that the printer can recognize the position of

the label.

NOTES: 1. Transparency rates are measured by the Macbeth TD-904 (with a filter for

infrared) photometer. The transparency rates are calculated as follows:

Use

Density = Log

Then,

Transparency rate (%) = (Amount of transparency / Amount of irradiation) × 100

(Amount of irradiation / Amount of transparency)

TITLE

TM-L90

Roll Paper

Manufacturing Guide

Label + Backing paper:

Transparency rate: 18% or less

Backing paper:

Transparency rate: 47% or more

SHEET

NO.

REVISION

SHEET