Motorola MR 11** TD-R Instrukcja serwisowa - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Radio Motorola MR 11** TD-R. Motorola MR 11** TD-R 23 stron. Radiotelephones

Motorola MR 11** TD-R Instrukcja serwisowa
IF Module
The IF module amplifies the 45 MHz signal from the mixer and provides the necessary channel
selection by the available crystal and ceramic filters. It supplies a demodulated AF signal to the
following AF-IC and provides the computer with an RSSI (received signal strength indicator) signal.
Power Supply (PS)
The power supply generates the necessary receiver voltage VRX. VRX is derived from the switched
battery voltage BATSWD and stabilised at 8 V. VRX is switched on and off by the control line
VTXCTRL.

3.2 Transmitter

Four adjustment values for four power stages are stored in the radio for the transmitter output
stages in production. One of these values can be assigned to the "High Power" stage switchable by
the user, another to the "Low Power" stage with the help of WinIPP in the after-sales service. This
can be done uniformly for all channels or separately for each channel. To ensure as constant as
possible an output power over the whole frequency range, four times four setting values for 146
MHz, 155 MHz, 165 MHz and 174 MHz are determined in automatic adjustment.
The switching times for reception-transmission, transmission-reception mode are less than 30
milliseconds. The power supplies for the transmitter are switched on and the T/R switch switched
to transmission mode via the control line VTXCTRL.
Transmitter Ouput Amplifier
The transmitter is available in three power ranges (1-6 W / 6-12 W / 12-25 W). The stored adjustment
values for the transmitter power in the MR radios are:
1-6 W:
1 W
6-12 W:
6 W
12-25 W:
12 W
The transmitter power of the MR 11 is keyed up with the aid of a D/A converter in the form of a
staircase function in two milliseconds. The setting values are passed to the transmitter via the
control line VPWRREF after a linear interpolation.

3.3 Antenna Filter with Antenna Switch

The antenna filter connects either the receiver pre-stage or the transmitter output to the antenna
socket. Its transmission function has band pass character. Switching is effected by PIN diodes.
The MR 11 harmonic filter is a low pass.
Motorola GmbH • Geschäftsbereich Funksysteme
I
2 W
6 W
6 W
12 W
12 W
25 W
.. - 1
<<
6 W
12 W
25 W
>>
MR 11
2 - 4