Philips VSS94705T Ważne uwagi - Strona 5

Przeglądaj online lub pobierz pdf Ważne uwagi dla Monitor Philips VSS94705T. Philips VSS94705T 7 stron. Colour observation monitor

Drukuj stronę

Operation

Power on/off
Push button at the rear of the monitor.
cable length
100m
0-50m
1 Power on
The slave monitor switches on.
There are two possibilities:
The system monitor is in power save mode.
•
The slave monitor starts in power save mode (system
mode indication LED is red).
The system monitor is in active mode.
•
The slave monitor performs the same image and sound
as the system monitor (system mode indication LED is
green).
2 Power off
The monitor switches off (system mode indication LED
is off).
Power save/active
1 Power active
Image and sound of the monitor are switched on (system
mode indication LED is green).
2 Power save
Image and sound of the slave monitor are switched off.
The system mode indication LED is red. When the
system monitor is in silent mode, the system mode
indication LED is amber.
When an alarm occurs and the system monitor is in
non-silent mode, the slave monitor switches on (system
mode indication LED is green).
Remark: When the system monitor is switched to power save
the slave monitor will also switch to power save.
Press
to switch the slave monitor to power active
again.
slave
in
out
200m
video
I O
audio
in
300m
slave aux
in
power
aux
power
CL 66610005_212.AI
CL 66610005_213.AI
Alarm

Monitor is used as slave monitor

When an alarm occurs:

1 The system monitor is in non-silent mode
The slave monitor switches automatically to 'power
•
active' if it was switched to 'power save'.
The slave monitor reproduces the camera image and
•
sound of the camera input which triggered the alarm.
The blinking message "AL" and the camera input
•
number is displayed at the bottom of the monitor screen.
A buzzer sounds for max. 3 minutes.
•
2 The system monitor is in silent mode and the slave
monitor is in power save mode
The system mode indication LED is red blinking.
•
3 The system monitor is in silent mode and the slave
monitor is in power active mode
The slave monitor reproduces the camera image and
•
sound of the camera input which triggered the alarm.
The blinking message "AL" and the camera input
•
number is displayed at the bottom of the monitor screen.

Reset alarm

The alarm resets whenever a button is pressed on the
system monitor (for more information you should
consult the manual of the system monitor).
Monitor is used as stand alone system
When you use the monitor as a stand-alone system a
beep will sound for 3 minutes if:
a camera cable-short occurs; the camera power is
•
switched off.
a cable is cut or a camera is disconnected.
•
Accessory boxes cannot be used in this simple
stand-alone system.

Trouble shooting

If the monitor does not show the camera image, then
check the following controls:
power on/off and power save/active
•
input selection switch
•
contrast
, brightness
, colour
•
Also check the connection to the monitor input.
6