3Com WL-306 Instrukcje dotyczące testu - Strona 3

Przeglądaj online lub pobierz pdf Instrukcje dotyczące testu dla Bezprzewodowy punkt dostępowy 3Com WL-306. 3Com WL-306 4 stron.

Antenna Selection:

On the open card there are two antenna connectors for the conducted testing as detailed in

the attached diagram. You can select between these two using the following command:

At the Debugging enabled prompt type:

a 0

{to select Antenna connection A}.

a 1

{to select Antenna connection B}

You will see a big change in the power levels if you switch between correct/incorrect

settings so please make sure that you are testing with the correct (maximum) setting.

Bit Rate selection:

The data rate can manually be selected using the following commands however it will

automatically drop, with distance, to the maximum possible under the connection

conditions.

At the Debugging enabled prompt type:

tr 110

{Sets to 11MBps}

tr 10

{Sets to 1MBps}

tr 20

{Sets to 2MBps}

tr 50

{Sets to 5MBps}

Setting up a connection to demonstrate the ETS 300 826 immunity test:

All the above tests can be performed using just one unit and one PC. I have also sent

you a WL-305 PC Card so that you can perform the ETS 300 826 tests and demonstrate

the connection. To do this please set up as follows:

The following example sets the Access Point (WL-306) to transmit a user specified (x)

number of packets to a WL-305 PC Card using channel 1.

Transmit PC from WL-306 (Use PC RA&A 73)

Click on the WL-306 icon on the desktop to bring you to the DOS prompt c:\speedracer

Type the following at the DOS prompt

C:\speedracer set poldebugmac=00-aa-bb-cc-dd-ee

C:\speedracer poldebug 4

{You should now be at the de-bugging prompt}.

>c 1

{Select the low channel}