Pioneer DEH-1120MP Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Odbiornik samochodowy Pioneer DEH-1120MP. Pioneer DEH-1120MP 8 stron. Cd rds receiver

Drukuj stronę

CD RDS RECEIVER

REPRODUCTOR DE CD CON RECEPTOR RDS

CD RDS-EMPFÄNGER

AUTORADIO CD RDS

SINTOLETTORE CD RDS

CD RDS-ONTVANGER

CD RDS ПРИЕМНИК

DEH-1120MP

DEH-1100MPB

DEH-1100MP

DEH-112E

DEH-110E

Installation Manual

Manual de instalación

Installationsanleitung

Manuel d'installation

Manuale d'installazione

Installatiehandleiding

Руководство по установке

Printed in Thailand

Imprimé en Thaïlande

<QRD3015-A/N> EW

Installation

Secure the mounting sleeve by using a

Important

screwdriver to bend the metal tabs (90°)

! Check all connections and systems before

into place.

final installation.

! Do not use unauthorized parts. Use of un-

Install the unit.

authorized parts may cause malfunctions.

Dashboard

Rubber bush

! Consult your dealer if installation requires dril-

ling of holes or other modifications to the vehi-

cle.

! Do not install this unit where :

— it may interfere with operation of the vehi-

cle.

— it may cause injury to a passenger as a re-

sult of a sudden stop.

! The semiconductor laser will be damaged if it

Mounting sleeve

Screw

overheats. Install this unit away from hot

places such as near the heater outlet.

! Optimum performance is obtained when the

Removing the unit

unit is installed at an angle of less than 60°.

Extend top and bottom of the trim ring

outwards to remove the trim ring. (When

60°

reattaching the trim ring, point the side

with a groove downwards and attach it.)

DIN front/rear mount

This unit can be properly installed either from

Trim ring

"Front" (conventional DIN front-mount) or

! It becomes easy to remove the trim ring if

"Rear" (DIN rear-mount installation, utilizing

the front panel is released.

threaded screw holes at the sides of unit chas-

sis). For details, refer to the following installa-

Insert the supplied extraction keys into

tion methods.

both sides of the unit until they click into

place.

DIN Front-mount

Pull the unit out of the dashboard.

Installation with the rubber bush

Insert the mounting sleeve into the

dashboard.

When installing in a shallow space, use a sup-

plied mounting sleeve. If there is enough

space behind the unit, use factory supplied

mounting sleeve.

Installation

DIN Rear-mount

Fastening the front panel

Extend top and bottom of the trim ring

If you do not plan to detach the front panel,

outwards to remove the trim ring. (When

the front panel can be fastened with supplied

reattaching the trim ring, point the side

screw.

with a groove downwards and attach it.)

Screw

Trim ring

! It becomes easy to remove the trim ring if

the front panel is released.

Determine the appropriate position

where the holes on the bracket and the

side of the unit match.

Tighten two screws on each side.

Screw

Mounting bracket

Dashboard or console

! Use either truss screws (5 mm × 8 mm) or

flush surface screws (5 mm × 9 mm), de-

pending on the shape of screw holes in the

bracket.