Ariston AWD 121 Instrukcje użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Spryskiwacz Ariston AWD 121. Ariston AWD 121 21 stron. Washer / washer-dryer combo
Również dla Ariston AWD 121: Instrukcja naprawy (20 strony), Instrukcja instalacji i użytkowania (17 strony)

Drukuj stronę

included i ntheaccessories supplied w iththismachine a re2

inbthoses and4 rubber w ashers, Thestraight endofthese

hoses shouUd beconnected tothesuppUy fig,1,

The90 ° angbdendofthesehoses shouUd beconnected t o

theinbtvaDes o nthebackofthemachine, using oneofthe

washers t omake a watertight seaU o neach connection,

The couli#£o_sshouUdbe tightened by han& a tooU shouUdonUy

be used if a bak occurs, Do not use excessive force (see M,

fig, 1),

The DO NOT USE AN EXTENSION CORD.

Repair or replacement of a part should be made only by a

qualified service technician to prevent personal injury or damage

to the machine, inlet valves are color coded:

Red

= Hot

White = Cold

runlet}

Connection

to the water

mains

Water pressure must range within the values indicated on the

data plate on the rear of your washer-dryer, if the water pipes are

new or left unused, then before connecting the machine run the

water until clear to remove debris, Connect the inlet hose to a

cold water tap having a sA"BSP thread, Ensure that there are

rubber washers are at each end of the inlet hose, The L-Shaped

end goes on the machine and straight ends on the water faucets

Note: Replace inlet hoses after 5 years of use to reduce the

risk of hose failure, Record hose installation or replacement

dates on the hoses for future reference,

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear or leaks are found,

Fig. ! - VC_t_r p ipc ir_/_'t_t the' mp ri£ht

PLUMBmNG

You should carefully position the drain hose to avoid kinks and

ensure proper drainage of the water,

The outlet end of the drain hose must be at bast 25" (62 cm)

above the base of the machine, At this point it is possible for

the water to be discharged into a sink or drain pipe, but an air

break must be available at this 24" height to prevent the machine

from syphoning (see fig, aside),

No more than 6" of the drain hose should be inserted in the

drain pipe,

IMPORTANT

make sure that the drain hose is not kinked and the water flow

has not been restricted,

25"i

34"

iNCHES

Standpipe

drain system:

in RV installation needs a 1-1/2 inch (3,7 cm) diam,

standpipe with minimum carry away capacity of 7 gallons (31

liters) per minute or 2" (5 cm) in home installation,

Floor Standpipe

drain:

Top of standpipe must be at bast 25 inches (62 cm) high and

no higher than 34 inches (86 cm) from the bottom of

washer(A),

Wall standpipe

drain:

25 inches (62 cm) min,; 34 inches (86 cm,) max

from end of drain hose to bottom of washer (B),

www.a ristonappliances,us

lnstrucdonsforinstalla_ionanduse