Ariston AWD 121 Kullanıcı Talimatları - Sayfa 7

Yıkayıcı Ariston AWD 121 için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Ariston AWD 121 21 sayfaları. Washer / washer-dryer combo
Ayrıca Ariston AWD 121 için: Onarım Kılavuzu (20 sayfalar), Kurulum ve Kullanım Kılavuzu için Talimatlar (17 sayfalar)

Ariston AWD 121 Kullanıcı Talimatları
included i ntheaccessories supplied w iththismachine a re2
inbthoses and4 rubber w ashers, Thestraight endofthese
hoses shouUd beconnected tothesuppUy fig,1,
The90 ° angbdendofthesehoses shouUd beconnected t o
theinbtvaDes o nthebackofthemachine, using oneofthe
washers t omake a watertight seaU o neach connection,
The couli#£o_sshouUdbe tightened by han& a tooU shouUdonUy
be used if a bak occurs, Do not use excessive force (see M,
fig, 1),
The DO NOT USE AN EXTENSION CORD.
Repair or replacement of a part should be made only by a
qualified service technician to prevent personal injury or damage
to the machine, inlet valves are color coded:
Red
= Hot
White = Cold
runlet}
Connection
to the water
mains
Water pressure must range within the values indicated on the
data plate on the rear of your washer-dryer, if the water pipes are
new or left unused, then before connecting the machine run the
water until clear to remove debris, Connect the inlet hose to a
cold water tap having a sA"BSP thread, Ensure that there are
rubber washers are at each end of the inlet hose, The L-Shaped
end goes on the machine and straight ends on the water faucets
Note: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure, Record hose installation or replacement
dates on the hoses for future reference,
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear or leaks are found,
Fig. ! - VC_t_r p ipc ir_/_'t_t the' mp ri£ht
PLUMBmNG
You should carefully position the drain hose to avoid kinks and
ensure proper drainage of the water,
The outlet end of the drain hose must be at bast 25" (62 cm)
above the base of the machine, At this point it is possible for
the water to be discharged into a sink or drain pipe, but an air
break must be available at this 24" height to prevent the machine
from syphoning (see fig, aside),
No more than 6" of the drain hose should be inserted in the
drain pipe,
IMPORTANT
make sure that the drain hose is not kinked and the water flow
has not been restricted,
j
m
25"i
34"
iNCHES
Standpipe
drain system:
in RV installation needs a 1-1/2 inch (3,7 cm) diam,
standpipe with minimum carry away capacity of 7 gallons (31
liters) per minute or 2" (5 cm) in home installation,
Floor Standpipe
drain:
Top of standpipe must be at bast 25 inches (62 cm) high and
no higher than 34 inches (86 cm) from the bottom of
washer(A),
Wall standpipe
drain:
25 inches (62 cm) min,; 34 inches (86 cm,) max
from end of drain hose to bottom of washer (B),
J
www.a ristonappliances,us
lnstrucdonsforinstalla_ionanduse
7