Pioneer PRS-D4200F - Premier Amplifier Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Pioneer PRS-D4200F - Premier Amplifier. Pioneer PRS-D4200F - Premier Amplifier 20 stron. Bridgeable four-channel power amplifier
Również dla Pioneer PRS-D4200F - Premier Amplifier: Instrukcja obsługi (50 strony), Instrukcja serwisowa (38 strony)

Pioneer PRS-D4200F - Premier Amplifier Instrukcja obsługi
Specifications
Power source
14.4 V DC (10.8 V to 15.1 V allowable)
Grounding system
Negative type
Current consumption
28 A (at continuous power, 4 n)
Average current drawn*
10 A (4 n for four channels)
20 A (4 n for two channels)
20 A (2 n for four channels)
l:'.~,.....
')" A ..
~"
rU1>1;
.JV
t"\
A ..
Dimensions
301 (W) mm x 57 (H) mm x 213 (D) mm
[12 (W) in x 2-1/4 (H) in x 8-3/8 (D) in]
Weight
3.5 kg (7.71bs.) (Leads for wiring not included)
Maximum power output
150 W x 4 (4 n) / 600 W x 2 (4 n)
Continuous power output
75 Wx 4 (at 14.4 V, 4 n, 20 Hz to 20 kHz 1.0% THD)
300 W x 2 (at 14.4 V, 4 n, 1kHz 1.0% THO)
150 W x 4 (at 14.4 V, 2 n, 1kHz 1.0% THO)
Load impedance
4 n (2 n to 8
n
allowable)
Frequency response
10 Hz to 50 kHz
(+0
dB, -3 dB)
Signal-to-noise ratio
100 dB (IHF-A network)
Distortion
0.005 % (10 W, 1kHz)
Separation
70 dB (1 kHz)
60 dB (100 Hz to 10 kHz)
Low pass filter
Cut off frequency: 40 Hz to 500 Hz
Cut off slope: -12 dB/oct
High pass filter
Cut off frequency: 40 Hz to 500 Hz
Cut off slope: -12 dB/oct
Gain control
RCA: 400 mV to 6.5 V
Speaker: 1.6 V to 26 V
Maximum input level/impedance
RCA: 6.5 V / 22 ill
Speaker: 26 V /90 kn
Power output
75 W RMS x 4 channels
(4 n and
~
I %THD+N)
300 W RMS x 2 channels
(4 n and
~
1 %THD+N)
150 W RMS x 4 channels
(2 n and
~
I %THD+N)
Signal-lo-noise ratio
80 dBA (Reference: 1W into 4 n)
Note:
• Specifications and the design are subject to possible modification without notice
due to improvements.
*
Average current drawn
• The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.