Pioneer PD-T507 Instrukcja obsługi - Strona 28

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odtwarzacz CD Pioneer PD-T507. Pioneer PD-T507 32 stron. Twin-tray compact disc player 1-bit dlc
Również dla Pioneer PD-T507: Instrukcja serwisowa (11 strony), Instrukcja serwisowa (11 strony)

Drukuj stronę

TO PLAYBACK A CD TO MATCH THE LENGTH OF A CASSETTE TAPE

oo 2 ©

To confirm the programmed results:

NOTES:

@ Up to 18 steps can be programmed.

@ A disc which contains more than 18 selections sometimes ¢ can-

_ _ _

not be programmed property.

®@ Programming will not be possible if the dise's tracks are'so jong

that not even one track can be recorded within one-half of the

designated time.

After completion of programming, press the EDIT button; each time.

the button is pressed, the program results will be. alternately dis-

played for tape sides A and B.

® If the tray.is.not open, the program contents will not be erased

even if the power is turned off.

However, if the power is turned off with an audio timer or un-

plugging the power cord, the program contents will be erased.

TROUBLESHOOTING

dealer to carry out.repair: work.

Symptom.

Disc tray does not come

Power plug is disconnected from

Connect-plug.to'stereo amplifier

out when.the:.

;

outlet.

or wall outlet.

OPEN/CLOSE button is

The POWER switch is OFF.

Press the POWER switch ON.

pressed.

When playback is start-

Disc

is loaded upside down.

Load the disc correctly with the

ed, it stops immediately.

label side UP.

Pauses or stops

Dirty disc, etc.

Remove:the dirt from the dise and then play it

playback

again.

No sound.

|.®.

Output cords are connected incorrectly or

Connect properly.

loosely.

;

Check the settings of stereo amplifier switches

and sound volume controls.

Player is in pause mode.

Press the PLAY or PAUSE button.

| ae

Sound is distorted, noise

| ®

Incorrect connections.

a e

Connect to amplifier CD or AUX terminals, etc.

is output.

Do not connect to PHONO

input terminals.

Pin plugs or amplifier input terminals are dirty.

Clean away dirt.

;

Interference is being picked up from a TV set.

Switch OFF TY set, or move player away from

;

TV set.

With certain discs, loud

Disc is badly scratched or warped.

Replace the disc.

noise is: produced, or

Disc is extremely dirty.

Clean disc.

play stops.

Mine

T R A T E S

8 g

My TV set's picture is

Interference is being picked up from the CD

| ®

Either turn off the CD player.or move the CD

disrupted (or, my. FM

player.

player farther away from the TV'set (and FM

tuner picks up lots of

tuner).

noise).

Cannot operate player

Batteries have runout. ~

l *

Replace batteries.

with remote control unit.

| ®

Remote control unit is too far away from play-

The operating range of the remote control unit,

(PD-T507 only)

er, or angle is-wrong.

is up to about 7 m from the remote sensor, wi-

Bie

thin angles of up to 30 degrees.

There is an obstacle between remote control

Operate the remote contro! unit from a differ-

unit and player.

ent position, or remove the obstacle.

En/Fr