Pioneer PD-T507 Інструкція з експлуатації Посібник з експлуатації - Сторінка 28
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Програвач компакт-дисків Pioneer PD-T507. Pioneer PD-T507 32 сторінки. Twin-tray compact disc player 1-bit dlc
Також для Pioneer PD-T507: Посібник з експлуатації (11 сторінок), Посібник з експлуатації (11 сторінок)
Друкувати сторінку
TO PLAYBACK A CD TO MATCH THE LENGTH OF A CASSETTE TAPE
oo 2 ©
To confirm the programmed results:
NOTES:
@ Up to 18 steps can be programmed.
@ A disc which contains more than 18 selections sometimes ¢ can-
_ _ _
not be programmed property.
®@ Programming will not be possible if the dise's tracks are'so jong
that not even one track can be recorded within one-half of the
designated time.
After completion of programming, press the EDIT button; each time.
the button is pressed, the program results will be. alternately dis-
played for tape sides A and B.
® If the tray.is.not open, the program contents will not be erased
even if the power is turned off.
However, if the power is turned off with an audio timer or un-
plugging the power cord, the program contents will be erased.
TROUBLESHOOTING
dealer to carry out.repair: work.
Symptom.
Disc tray does not come
@
Power plug is disconnected from
®
Connect-plug.to'stereo amplifier
out when.the:.
;
outlet.
or wall outlet.
:
OPEN/CLOSE button is
®
The POWER switch is OFF.
@
Press the POWER switch ON.
pressed.
When playback is start-
Disc
is loaded upside down.
Load the disc correctly with the
ed, it stops immediately.
label side UP.
Pauses or stops
©
Dirty disc, etc.
°
Remove:the dirt from the dise and then play it
playback
:
again.
No sound.
.
|.®.
Output cords are connected incorrectly or
e
Connect properly.
loosely.
;
;
'
© 'Incorrect operation of stereo amplifier.
e
Check the settings of stereo amplifier switches
and sound volume controls.
©
Player is in pause mode.
e
Press the PLAY or PAUSE button.
| ae
Sound is distorted, noise
| ®
Incorrect connections.
a e
Connect to amplifier CD or AUX terminals, etc.
is output.
me
dl
Do not connect to PHONO
input terminals.
:
e
Pin plugs or amplifier input terminals are dirty.
@
Clean away dirt.
;
©
Interference is being picked up from a TV set.
¢
Switch OFF TY set, or move player away from
;
TV set.
With certain discs, loud
@
Disc is badly scratched or warped.
e
Replace the disc.
noise is: produced, or
°
Disc is extremely dirty.
e
Clean disc.
play stops.
Mine
T R A T E S
8 g
ee
My TV set's picture is
e
Interference is being picked up from the CD
| ®
Either turn off the CD player.or move the CD
disrupted (or, my. FM
a,
player.
player farther away from the TV'set (and FM
tuner picks up lots of
tuner).
noise).
Cannot operate player
©
Batteries have runout. ~
l *
Replace batteries.
with remote control unit.
| ®
Remote control unit is too far away from play-
e
The operating range of the remote control unit,
(PD-T507 only)
er, or angle is-wrong.
:
:
is up to about 7 m from the remote sensor, wi-
ua
oi
Bie
thin angles of up to 30 degrees.
-
*
There is an obstacle between remote control
e
Operate the remote contro! unit from a differ-
unit and player.
|
ent position, or remove the obstacle.
28
<PRE1143>
En/Fr