Whirlpool 3LCHW9100WQ0 Instrukcja instalacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Spryskiwacz Whirlpool 3LCHW9100WQ0. Whirlpool 3LCHW9100WQ0 48 stron. Semi-pro front-load washer
Drukuj stronę
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the washer
is within approximately
900 mm (3 ft.) of its final location.
There are 4 shipping bolts in the rear panel of the washer that
support the suspension
system during transportation.
These
bolts also retain the power cord inside the washer until the bolts
are removed.
1. Keep the washer in the upright position while removing the
shipping bolts.
2. Using a 1/2" wrench, loosen each of the bolts.
3. Once the bolt is loose, move it to the center of the hole and
completely
pull out the bolt, including the plastic spacer
covering the bolt.
4. Once all 4 bolts are removed, discard the bolts and spacers.
Then push the power cord plug into the opening on the right
side of the rear panel and pull the power cord through the
opening on the left side of the rear panel and close holes with
the attached cap. Do not pull plug end of power cord through
the right side hole.
5. Close the bolt holes with the 4 transport
bolt hole plugs.
NOTE: If the washer is to be transported
at a later date, call your
product distributor or installer. To avoid suspension and structural
damage, your washer must be properly set up for relocation by a
trained professional.
1.
2.
3.
4.
5.
Select the plug that fits with the electric receptacle.
Assemble the plug into the end of the power cord.
Secure the power cord by seating the connection
on the cord
lock.
Place the cord lock cover and push until it snaps.
Make sure the power cord connection
is seated
on the cord
lock and that the cord lock clamps
correctly.
Insert new flat washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
A
B
A. Coupling
B. Washer
•
Use the new inlet hoses supplied with washer. Do not re-use
old inlet hoses.
Connect the inlet hoses to the water taps
Make sure the washer drum is empty.
1. Attach a hose to the hot water tap. Screw on coupling
by hand until it is seated on the washer.
2. Attach a hose to the cold water tap. Screw on coupling
by hand until it is seated on the washer.