Whirlpool ALA 101 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Whirlpool ALA 101. Whirlpool ALA 101 20 stron.

TROUBLESHOOTING

ERROR MESSAGES

If an error occurs during the programme a message is

shown on the display. To exit the message after taking

measures, turn the machine oﬀ and then back on.

The error messages that may be shown in the display

are:

Close the Door

Close the washer door and press Start to start the

programme.

Over ﬂ ow fault

1 Shut oﬀ the water tap.

2 See "Drainage error".

Water outlet fault

Check:

• that no objects are stuck in the drainage hose outlet.

• that the drainage pump is not blocked by foreign

objects. Clean the pump. See the "Care and cleaning"

chapter.

• that there are no kinks in the drainage hose.

Press the Stop button to empty the machine of water

before opening the washer door. If this does not resolve

the problem, call the service division.

Water inlet fault

Check:

• that the tap on the water pipe is open.

• that the ﬁ lter in the machine's water intake is not

blocked.

Action:

1 Shut oﬀ the water tap and unscrew the hose.

2 Clean the ﬁ lter in the intake valve on the machine.

3 Screw the hose back on and turn on the tap.

4 Run the program again to check if the fault is ﬁ xed.

5 If this does not resolve the problem, call the service

division.

Wash motor fault

Call the service division!

Unbalance

The machine stops the spin cycle if there is too much

imbalance. The washing machine restarts the spin

cycle and hopefully the washing is better distributed

in the drum. This procedure can be repeated up to 10

times. If the machine still fails to ﬁ nd a good balance, the

programme jumps to the next step.

The error message requires no action.