Whirlpool ALA 101 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Whirlpool ALA 101. Whirlpool ALA 101 20 stron.

INSTALLATION

The washing machine can be installed as a built-in or

freestanding unit. Place the machine on a ﬁ rm surface

with easy access to the plug.

A. Built-in

The washing machine can be installed under a counter

top with a working height of 850-900 mm. Leave a 5 cm

space around the entire machine, including between the

rear edge of the top cover and the wall behind it.

B. Freestanding

The washing machine can be positioned beside or under

a tumble dryer.

Keep the noise that the machine produces to a minimum

by adjusting the feet so that the machine is steady and

balanced on he ﬂ oor. Tighten the lock nuts.

Locking nut

Water connection should be carried out by an

appropriately qualiﬁ ed person. Connect the machine

using the accompanyingsupply hose. Water pressure

should be 0.1–1MPa (approx. 1–10kp/cm

). There should be a stopcock on the water pipe.

If the pipes are newly installed, it may be wise to ﬂ ush

them through so that any dirt is washed away. Otherwise,

dirt can clog the ﬁ lter in the machine's water intake and

cut oﬀ the water supply.

Use only the supply hose supplied with the machine. Do

not re-use old hoses or other loose supply hoses.

Water intake

At the factory, the machine is set for connecting to both

hot and cold water supplies. The machine can be set for

cold water intake only. See the section "Settings".

Hot water connection

A few seconds after you start a programme the washing

machine will begin to ﬁ ll with water from both the hot

and the cold supplies. If for some reason no hot water

is available, the machine waits for one minute and then

ﬁ lls with cold water only. The wash drum does not start to

rotate until it begins to ﬁ ll with water.

If the appliance is not connected to the hot water line,

then deactivate the function in the User Menu.

(See chapter Settings.)

; 10–100N/