Whirlpool AKR 507 IX Instrukcja montażu i użytkowania - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja montażu i użytkowania dla Okap wentylacyjny Whirlpool AKR 507 IX. Whirlpool AKR 507 IX 7 stron.
Drukuj stronę
Sponge filter should be washed with hot soapy water once a
month and replaced every 5 to 6 washes.
Metallic filter must be cleaned once a month, with non
abrasive detergents,
by hand or in dishwasher on low
temperature and short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
In order to remove the grease filter open the grill via the P
hooks and free the R1 or R2 stoppers.
The self-supporting metal filter does not include a support
grill, in order to remove the filter – pull the release springs P4
backwards and slide the filter downwards.
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the activated charcoal occurs after more or
less prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths.
The carbon filter may NOT be washed or regenerated.
Remove the grease filters.
Fit the charcoalfilters over the motor.
Align the pins V on the cowl with the slots Z, then turn the
filter anti-clockwise until it locks in place.
Reverse the above procedure to remove the charcoal filters.
Refit the grease filters.
Replacing lamps
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Replacing lightbulbs 40W - Unscrew the damaged light bulb
and replace with an incandescent oval light bulb with a
maximum of 40W E14. Remove the grill in order to reach the
light bulb area.
Replacing the halogen bulbs - Access the light compartment
– extract the lamp cover by levering it off with a small
screwdriver or similar tool.
Replace the damaged light bulb. Only use halogen bulbs of
20W max (G4), making sure you do not touch them with your
hands. Close the lamp cover (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
After-sales service
Before calling the After-Sales Service:
1.
See if you can solve the problem yourself with the help of
the suggestions given in the "Troubleshooting guide".
2.
Switch the appliance off and back on again it to see if the
fault persists.
If after the above checks the fault still occurs, get in touch
with
the
nearest
Always specify:
•
a brief description of the fault;
•
the exact type and model of the appliance;
After-sales
Service.
•
the service number (number after the word Service on
the rating plate), located on the inside of the appliance.
The service number is also indicated on the guarantee
booklet;
•
your full address;
•
your telephone number.
If any repairs are required, please contact an authorised
After-sales Service (to guarantee that original spare parts will
be used and repairs carried out correctly).
7
LIB0001101 Ed. 02/10