Firesense 61322 Podręcznik - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik dla Grzałka Firesense 61322. Firesense 61322 14 stron. Outdoor tabletop heater

Drukuj stronę

OPERATING INSTRUCTIONS

•

The tabletop heater is for outdoor use only. Always

ensure that adequate fresh air ventilation is

provided.

•

Always maintain proper clearance to combustible

materials, i.. e. top 18" and sides 24" minimum.

•

Tabletop heater must be located on a stable and

strong surface.

•

Never operate heater in an explosive atmosphere

such as in areas where gasoline or other flammable

liquids or vapors are stored.

LEAK TEST

1. Make 2-3 oz. of leak test solution

(one part liquid dish washing

detergent and three parts water).

2. Apply several drops of solution

where hose attaches to regulator.

3. Apply several drops of solution

where regulator connects to cylinder.

4. Make sure all patio heater valves are OFF.

5. Turn cylinder valve ON.

IF BUBBLES APPEAR AT ANY CONNECTION, THERE IS A LEAK.

1. Turn cylinder valve OFF.

2. If leak is detected at hose/regulator connection, tighten connection and

perform another leak test. If bubbles continue to appear, call our customer

service hotline at (866) 985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday.

3. If leak is detected at regulator/cylinder valve connection, disconnect,

reconnect, and perform another leak test. If you continue to see bubbles

after several attempts, cylinder valve is defective. Call our customer service

hotline at (866) 985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday.

IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS

ARE SECURE.

Note: Whenever gas connections are loosened or removed, you must perform

a complete leak test.

TABLETOP HEATER LOCATION

• Perform all leak tests outdoors.

• Extinguish all open flames.

• NEVER leak test when smoking

• Do not use heater until all connections

have been leak tested and show no signs

of leakage.

BEFORE TURNING GAS SUPPLY ON:

WARNING

BEFORE LIGHTING:

1. Your heater was designed and

approved for OUTDOOR use

only. Do NOT use it inside a

building, garage, or any other

enclosed area.

2. Make sure surrounding areas are

free of combustible materials,

gasoline, and other flammable

vapors or liquids.

3. Ensure that there is no

obstruction to air ventilation. Be

sure all gas connections are tight

and there are no leaks.

4. Be sure the cylinder is clear of

debris. Be sure any component

removed during assembly or

servicing is replaced and

fastened prior to starting.

1. Heater should be thoroughly

inspected before each use, and

by a qualified service person at

least annually. If re-lighting a

hot heater, always wait at least

5 minutes.

2. Inspect the hose assembly for

evidence of excessive abrasion,

cuts, or wear. Suspected areas

should be leak tested. If the

hose leaks, it must be replaced

prior to operation. Only use the

replacement hose assembly

specified by the manufacturer.