fireStorm SEQ18 Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający fireStorm SEQ18. fireStorm SEQ18 14 stron.

METHOD OF OPERATION

Note: We recommend minimising the amount of time the unit is switched on when

pyrotechnics are connected. This minimises the chance of an accidental firing.

1. Set key to ON. Ensure unit passes self test.

2. Set mode using rotary knob.

3. Set intervals using rotary knob.

4. Press PLAY button to run the sequence on LEDs. No channels will be fired.

5. When satisfied sequence is correct, carefully connect igniters to terminals.

ENSURE AREA IS CLEAR AND SAFE FOR CONTINUITY CHECK!

6. Press TEST to check channel continuity on LEDs.

7. Set key to ARM.

UNIT IS NOW DANGEROUS AND READY TO FIRE.

8. Press FIRE button or provide external Trigger Input to start the sequencer.

1. Do not fire many cues at the same time / overlapping cues. The total current available

is limited to about 4 Amps per block of 18

channels to protect the internal circuitry. To

fire many channels at once we recommend

setting a very small delay between channels,

e.g. 10ms. This will be almost imperceptible

to the human eye but will allow each effect to

be fired individually. Pyro igniters normally

burn out open circuit under 5ms. Ideally

solenoids should not overlap. However for low

current solenoids it will be possible to overlap

several.

2. Remove igniter wires carefully by pressing

both terminals down together and removing

the wires. Grabbing a bunch of wires and

pulling them out roughly may damage the

connections. Spare user replaceable terminal

strips are available should this happen.

3. Wires can be connected neatly and securely

by wrapping each leg around the terminals as

shown opposite.

9 of 13