Alcohol Countermeasure Systems Alcolock V3 B-2 Series Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt testowy Alcohol Countermeasure Systems Alcolock V3 B-2 Series. Alcohol Countermeasure Systems Alcolock V3 B-2 Series 20 stron.
Drukuj stronę
SHARING A VEHICLE
Drivers with their own handset can operate the same vehicle without reprogramming
the ALCOLOCK V3 device. All the custom settings are downloaded into the ECU when
a new handset is connected.
The handset can be changed with the motor on or off.
It is recommended to exchange handsets when the motor is off and the vehicle is
parked at a safe location.
5
1. Pinch the connector at the sides and pull the cable away from
the handset to disconnect.
WARNING! Do not pull on the handset cord. It requires just a
gentle squeeze on the release tabs to disconnect.
2. If the motor is running, the ECU beeps every 15 seconds until
the handset is reconnected.
If the motor is off the ECU will not beep.
3. Reconnect the handset to the handset cable. It makes a click
sound if it is properly connected.
All the handset settings are downloaded to the ECU.
NOTE: If the handset is replaced while the motor is running, a
breath test is required.
ALCOLOCK V3 SERIES B-2