Yamaha AX-497 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Yamaha AX-497. Yamaha AX-497 24 stron. Stereo amplifier
Również dla Yamaha AX-497: Instrukcja obsługi (23 strony), Instrukcja serwisowa (36 strony)

Drukuj stronę

CONNECTIONS

Remove approximately 10 mm (318 in) of

insulation from the end of each speaker

cable and twist the exposed wires of the

cable together to prevent short circuits.

•

Connecting the banana plug

(With the exception of Asia, Korea, U.K. and

Europe models)

First, tighten the knob and then insert the banana plug into

the end of the corresponding terminal.

Unscrew the knob.

Banana plug

• One or two speaker sets can be connected to this unit. If you use

only one speaker set, connect it to either the SPEAKERS A or B

terminals.

• Use speakers with the specified impedance shown on the rear

panel of this unit.

Red: positive (+)

Black: negative (-)

Insert one bare wire into the hole in the side

of each terminal.

Red: positive (+)

Black: negative (-)

Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (-)