Zanussi ZV 190 P Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamrażarka Zanussi ZV 190 P. Zanussi ZV 190 P 8 stron.

Drukuj stronę

CUSTOMER SERVICE AND SPARE PARTS

Before calling your local dealer for servicing

assistance, check the following points to see if

you may not resolve the problem yourself:

Make sure that the freezer is plugged into the

wall socket correctly, and that electrical current

arrives to the freezer without interruption.

Control the thermostat setting.

In the event that the freezer makes excessive

noise or vibration, make sure that it is not in direct

contact with the wall or adjacent furniture.

If defective operation continues after these

controls, call your local Service Network and

provide all the data listed on the rating plate:

model, serial number, etc.

INSTALLATION

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc. Best performance is obtained with

ambient temperature between

+18¡C and +43¡C(class T);

+18¡C and +38¡C (class ST);

+16¡C and +32¡C (class N);

+10¡C and +32¡C (class SN).

The class of your appliance is shown on its

rating plate.

Ensure that air can circulate freely around the back

of the cabinet. To ensure best performance, if the

appliance is positioned below an overhanging wall

unit, the minimum distance between the top of the

cabinet and the wall unit must be at least 100 mm

(A). Ideally, however, the appliance should not be

positioned below overhanging wall units (B).

Accurate levelling is ensured by one or more

adjustable feet at the base of the cabinet.

Important

It is essential that the appliance be connected to an

efficient earth tap. For this purpose the supply cable

plug incorporates a special earth contact. If the

sockets of your domestic wiring system are not

earthed, have the appliance connected to a separate

earth wire by a qualified electrician in accordance

with existing safety regulations.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with EEC directive

number 87/308 of 2/6/87 relative to radio

interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent mod)fications;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply. Voltage

can vary by ±6% of the rated voltage.

NP006