Zanussi ZV 190 P Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamrażarka Zanussi ZV 190 P. Zanussi ZV 190 P 8 stron.

Drukuj stronę

Rear spacers

The plastic bag containing all relevant documentation

also contains two rear wall spacers to be fitted into spe-

cial slots on the back of the appliance. Fit the spacers

into the slots, taking care to ensure that the arrow (A) is

positioned as shown in the figure. Next, turn them

through 45¡ (arrow in vertical position) until they lock into

place.

Door reversal

Unplug the appliance before all operations.

To reverse the door, proceed as follows:

1. dismantle the lower hinge (3), pin (1) and the screw

(2);

2. slide the door out from pin (D),unscrew the pin and

reposition on the opposite side;

3. unscrew the left front foot and reposition on the oppo-

site side;

4. unscrew the two screws which mask the holes for fix-

ing the hinge from the left front side;

5. reassemble the door;

6. reassemble the lower hinge (turning it 180¡), the pin

and the screw on the opposite side, as shown in the

figure;

7. remove the handle, after having removed the screw

cover and refit it on the opposite side. The holes that

are not used must be mask with the plastic plugs

removed.

Warning:

After having reversed the opening direction of the

doors check that all the screws are properly tight-

ened and that the magnetic seal adheres to the cabi-

net. If the ambient temperature is cold (i.e. in Wõnter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket or accelerate this

process by heating up the part involved with a normal

hairdrier.

Fitting the door panel

(for models equipped with door frame)

To fit the door panel, proceed as follows:

remove the fixing screws and remove the frame side

opposite the handle;

loosen, without removing them, all remaining screws

fixing the door frame;

insert the panel from the side on which the frame has

been removed and push it fully in;

refit the frame side and tighten all the screws.

Note

The panel size should be 1-2 mm smaller than the door;

the maximum permissible panel thickness is 4 mm.

PR60

D590

D299