Zanussi ZCG560G Podręcznik użytkownika - Strona 17
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kuchenki Zanussi ZCG560G. Zanussi ZCG560G 20 stron. Zanussi zcg560g cooker user manual
Również dla Zanussi ZCG560G: Podręcznik użytkownika (20 strony)
Drukuj stronę
• If you change from liquid gas to natural gas,
undo the by-pass screw approximately 1/4 of
a turn.
Warning! Make sure the flame does not
go out when you quickly turn the knob
from the maximum position to the minimum
position.
Oven injector replacement
1. Remove the bottom plate of the oven cavity
(A) to get access to the oven burner (B).
2. Release the screw (C) which keeps the
burner in position.
3. Carefully move the burner off the injector
support (D).
Slowly move it to the left side. Make sure
that the burner bush stays on the burner
mouthpiece. Do not apply force to the wire
of the thermocouple conductor (F).
4. Release the injector (D) with a 7 mm sock-
et spanner and remove it. Replace it with
the necessary one.
5. Assemble the burner in opposite se-
quence.
6. Replace the gas type sticker near the gas
supply ramp with the one related to the
new gas type.
Minimum level adjustment of the gas
oven burner:
www.zanussi.com
1. Remove the oven control knob.
2. Adjust the adjustment screw (A) with a
thin-bladed screwdriver.
A
Change of the type
of gas
From natural gas to
liquid gas
From liquid gas to
natural gas
3. Attach the oven control knob.
4. Light the oven burner. Refer to "Gas oven
cooking: Ignition of the gas oven burner".
5. Set the oven control knob to maximum and
let the oven heat for a minimum of 10 mi-
nutes.
6. Turn the oven control knob from maximum
to minimum.
Control the flame. If the flame goes out, do the
procedure from point 1 to point 6 again. There
must be a small regular flame on the oven burn-
er crown.
The manufacturer declines liability if you
do not obey these safety measures.
Levelling
Use small feet on the bottom of appliance to
set same level of cooker top surface with other
surfaces
Adjustment of the
adjustment screw
Fully tighten the ad-
justment screw in.
Release the adjust-
ment screw approxi-
mately 3/4 of a turn.
17