Zanussi ZCG63040XA Podręcznik użytkownika - Strona 18
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kuchenki Zanussi ZCG63040XA. Zanussi ZCG63040XA 25 stron.
Drukuj stronę3. Remove the glass panels.
To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part to
the door. Refer to the image.
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
The burners do not work.
There is no spark when you try
to activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
The flame colour is orange or
yellow.
18
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300 °C
heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
The appliance is too hot.
There is no gas supply.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
The lamp glass cover is at the back of
the cavity.
Remedy
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Wait for the appliance to cool
down.
Check the gas connection.
Place the burner cap and
crown correctly.
After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
Make sure that the injector is
not blocked and the burner
crown is clean.
The flame can look orange or
yellow in some areas of the
burner. This is normal.