Clarke SHHHAIR 30 Instrukcja obsługi i konserwacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprężarka powietrza Clarke SHHHAIR 30. Clarke SHHHAIR 30 17 stron. Silent air compressor
Drukuj stronę
SWITCHING THE AIR COMPRESSOR ON
1. To start the compressor, use your
foot to press and hold down the
ON/OFF switch - the motor should
start immediately.
NOTE: If the motor fails to start
immediately, the air receiver
may already be full of air.
Check the tank pressure
gauge (shown on the right).
If you release air, by opening
the air outlet tap, the motor
will start automatically once the cut-in pressure is reached.
2.
Allow the compressor to run for 10-
15 seconds, with the air outlet tap,
(A) open.
• This will distribute the lubricating
oil.
3. Close the outlet tap and connect
a suitable air hose to the filter/
regulator outlet (B). Connect the
other end to the equipment to be
used.
4. Adjust the pressure regulator.
• To do this, lift the pressure regulator knob (C), and turn it clockwise to
increase the pressure, anticlockwise to decrease the pressure. The
pressure is shown on the outlet gauge, (D).
• To lock the pressure regulator knob (C) in place, press down until it
clicks into place.
IMPORTANT: Always refer to the accessory manufacturers recommendations for
optimum operating pressures for their equipment.
5. Check the safety valve by pulling
on the ring shown, air should hiss
out when pulled.
D
A
B
7
C
E