Clarke SHHHAIR 30 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke SHHHAIR 30에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke SHHHAIR 30 17 페이지. Silent air compressor

SWITCHING THE AIR COMPRESSOR ON

1. To start the compressor, use your

foot to press and hold down the

ON/OFF switch - the motor should

start immediately.

NOTE: If the motor fails to start

immediately, the air receiver

may already be full of air.

Check the tank pressure

gauge (shown on the right).

If you release air, by opening

the air outlet tap, the motor

will start automatically once the cut-in pressure is reached.

Allow the compressor to run for 10-

15 seconds, with the air outlet tap,

(A) open.

• This will distribute the lubricating

oil.

3. Close the outlet tap and connect

a suitable air hose to the filter/

regulator outlet (B). Connect the

other end to the equipment to be

used.

4. Adjust the pressure regulator.

• To do this, lift the pressure regulator knob (C), and turn it clockwise to

increase the pressure, anticlockwise to decrease the pressure. The

pressure is shown on the outlet gauge, (D).

• To lock the pressure regulator knob (C) in place, press down until it

clicks into place.

IMPORTANT: Always refer to the accessory manufacturers recommendations for

optimum operating pressures for their equipment.

5. Check the safety valve by pulling

on the ring shown, air should hiss

out when pulled.