Directed XpressKit DBALL Instrukcja instalacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przez blokady Directed XpressKit DBALL. Directed XpressKit DBALL 16 stron. Ford5 remote start ready (rsr) installation
Również dla Directed XpressKit DBALL: Podręcznik (14 strony), Instrukcja instalacji (16 strony), Podręcznik (19 strony)
Drukuj stronę
Platform: DBALL/DBALL2
Firmware: CHRYSLER7 Range Extender Ready (RXT) Installation
LED Diagnostics & Troubleshooting
LED
Status
Module programming - Firmware specific
Solid
Solid red
Flashes green
Flashes
fast
Flashes orange
Flashes
quickly
Solid orange for 3
Solid
seconds
Module programming - Error codes
LED
Description
Flashes
CAN not
red x2
detected.
Flashes
Bypass data not
red x3
detected.
Description
Waiting for module programming.
Normal. CAN programmed and w aiting for
bypass programming.
Module in RXT mode w aiting for Ignition.
Module successefully programmed in RXT.
Troubleshooting
Check the Tan - Tan/Black w ire
connections. Wake up the data bus by
turning the ignition on and try again.
Module not in RXT. Press 5 times on
programming button before turning ignition
ON. See module programming.
Troubleshooting
Press 5 times on programming button. See module programming section.
Normal operation
Check for CAN-High and CAN-Low connections as the Ignition is not seen
CAN.
Normal operation
Comment
Make sure the battery w as removed w hen turning the ignition ON.
Rev.: 20141117
Page 10
© 2014 Directed. All rights reserved.