Directed XpressKit DBALL Посібник з монтажу - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу для За замками Directed XpressKit DBALL. Directed XpressKit DBALL 16 сторінок. Ford5 remote start ready (rsr) installation
Також для Directed XpressKit DBALL: Посібник (14 сторінок), Посібник з монтажу (16 сторінок), Посібник (19 сторінок)
Друкувати сторінку
Platform: DBALL/DBALL2
Firmware: CHRYSLER7 Range Extender Ready (RXT) Installation
LED Diagnostics & Troubleshooting
LED
Status
Module programming - Firmware specific
Solid
Solid red
Flashes green
Flashes
fast
Flashes orange
Flashes
quickly
Solid orange for 3
Solid
seconds
Module programming - Error codes
LED
Description
Flashes
CAN not
red x2
detected.
Flashes
Bypass data not
red x3
detected.
Description
Waiting for module programming.
Normal. CAN programmed and w aiting for
bypass programming.
Module in RXT mode w aiting for Ignition.
Module successefully programmed in RXT.
Troubleshooting
Check the Tan - Tan/Black w ire
connections. Wake up the data bus by
turning the ignition on and try again.
Module not in RXT. Press 5 times on
programming button before turning ignition
ON. See module programming.
Troubleshooting
Press 5 times on programming button. See module programming section.
Normal operation
Check for CAN-High and CAN-Low connections as the Ignition is not seen
CAN.
Normal operation
Comment
Make sure the battery w as removed w hen turning the ignition ON.
Rev.: 20141117
Page 10
© 2014 Directed. All rights reserved.