Blackberry RADAR H2 ITC100-1 Instrukcja instalacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Radar Blackberry RADAR H2 ITC100-1. Blackberry RADAR H2 ITC100-1 30 stron. Magnet accessory
Również dla Blackberry RADAR H2 ITC100-1: Instrukcja instalacji (33 strony), Instrukcja instalacji (28 strony), Instrukcja instalacji (35 strony), Instrukcja instalacji (25 strony), Instrukcja instalacji (35 strony)

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE

2. After selecting the best installation location for your van, remove the adhesive from

the rear of the template and place the template in the desired installation location.

The adhesive at the back of the template ensures that it stays on the door surface for

accurate drilling of your holes.

IMPORTANT: When mounting under a vehicle, or a piece of equipment, you

must exercise a high degree of caution to avoid serious damage to yourself,

the module, or your equipment:

Do not install near exhaust sources, ignition sources, or fuel tanks.

•

Use caution when installing near pneumatic, hydraulic, and electrical

•

lines to avoid damage to these systems during installation.

3. Using a drill bit, drill a hole through each of the cross hairs on the template. This will

create four holes you will use to mount the module.