Blackberry RADAR H2 ITC100-1 설치 매뉴얼 - 페이지 12
{카테고리_이름} Blackberry RADAR H2 ITC100-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Blackberry RADAR H2 ITC100-1 30 페이지. Magnet accessory
Blackberry RADAR H2 ITC100-1에 대해서도 마찬가지입니다: 설치 매뉴얼 (33 페이지), 설치 매뉴얼 (28 페이지), 설치 매뉴얼 (35 페이지), 설치 매뉴얼 (25 페이지), 설치 매뉴얼 (35 페이지)
페이지 인쇄
42
BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE
2. After selecting the best installation location for your van, remove the adhesive from
the rear of the template and place the template in the desired installation location.
The adhesive at the back of the template ensures that it stays on the door surface for
accurate drilling of your holes.
IMPORTANT: When mounting under a vehicle, or a piece of equipment, you
must exercise a high degree of caution to avoid serious damage to yourself,
the module, or your equipment:
Do not install near exhaust sources, ignition sources, or fuel tanks.
•
Use caution when installing near pneumatic, hydraulic, and electrical
•
lines to avoid damage to these systems during installation.
3. Using a drill bit, drill a hole through each of the cross hairs on the template. This will
create four holes you will use to mount the module.