Directed Electronics 3808A Instrukcja instalacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa Directed Electronics 3808A. Directed Electronics 3808A 18 stron. Auto-mate
Drukuj stronę
System Testing and Impact Sensor Adjusting
RF Security Setting
Arming
1. Press the
button on the remote
2. Doors lock, Lights flash and the horn/siren sounds once
•
For silent arming; press the AUX button prior to pressing the
3. Dome light turns off, starter kill becomes active, and the status LED begins flashing.
4. While arming, the system tests the trigger inputs for status. If any trigger inputs are active when arming
the horn/siren sounds a second time as a notification, both the onboard impact sensor and the active
A U X
input are bypassed. The open zone is bypassed until corrected and the impact sensor is bypassed for
a maximum of 4 minutes. While bypassed, the active input is indicated by the status LED flashes (see
table of zones for LED flashes).
5. Sensor testing:
a. Gently impact the vehicle with increasing intensity to test the pre-trigger level (10 horn/siren sounds.
b. Impact that location more heavily to test the full-trigger level (horn/siren/lights for 30 sec.)
c. Adjust the sensor pot until the desired levels are obtained
Note: The Nuisance Prevention feature bypasses the sensor after three full-triggers; to reset if active,
disarm the system and turn the ignition on/off.
6. Protected entry tests:
•
Open each door, the horn/siren sounds quickly and then begin the full-trigger output
•
Open the hood or trunk, or turn on the ignition to immediately begin the full-trigger output.
Note: The Nuisance Prevention feature bypasses an input that stays active for three full-triggers; close the
input to reset.
Sensor Bypass
1. Press and release the AUX button within 5 seconds after
pre-trigger output is bypassed
2. Press and release the AUX button again within 5 seconds, the lights flash three times and the pre-trig-
ger and full-trigger outputs are bypassed
3. Press the
button anytime to reset the sensor
Disarming
1. Press the
button
2. Doors unlock, Lights flash and the horn/siren sounds two times. If the system has been triggered, the
horn/siren sounds four times or five times if the sensor is bypassed
A U X
•
For silent disarming; press the AUX button prior to pressing the
A U X
3. Dome light turns on, starter kill becomes inactive, and the status LED turns off.
•
If triggered, the status LED continues to flash to indicate triggered inputs (see table of zones). Turn
on the ignition to reset the LED.
4. Press the
button again to unlock the passenger doors if 2nd unlock is connected
Trunk Release
1. Press and hold the AUX button
A U X
2. Factory alarm will disarm if the output is connected
3. Trunk opens
Note: If the system is armed, the trunk input and sensor is bypassed until the trunk is closed. Trunk shunt
AUX
AUX
bypass requires the Blue trunk trigger input to be connected to the vehicle to bypass when armed (see Blue
wire description for wiring information).
AUX
AUX
Panic
1. Press and hold the
2. The lights flash and the horn/siren sounds for 30 seconds.
3. Press the
,
or
Car Finder
1. Press and release the AUX button prior to pressing the
2. The horn/siren emits one sound and the lights flash 10 times
3. Press the
or
buttons to stop the feature.
A U X
© 2012 Directed. All rights reserved.
A U X
A U X
button
buttons to reset
A U X
button.
A U X
button, the lights flash two times and the
A U X
A U X
AUX
AUX
button
button.
15