Directed Electronics 3808A Instrukcja instalacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa Directed Electronics 3808A. Directed Electronics 3808A 18 stron. Auto-mate
Drukuj stronę
OEM Security Setting
Arming
1. Press the Lock button on the OEM remote
2. Doors lock, lights flash and the horn/siren sounds once, starter kill becomes active, and the status LED
begins flashing.
3. While arming, the system tests the trigger inputs for status. If any trigger inputs are active when arming
the horn/siren sounds a second time as a notification, both the onboard impact sensor and the active
input are bypassed. The open zone is bypassed until corrected and the impact sensor is bypassed for
a maximum of 4 minutes. While bypassed, the active input is indicated by the status LED flashes (see
table of zones for LED flashes).
4. The shock sensor is enabled after a one minute delay.
Note: The system can be disarmed if the ignition is turned on during this one minute delay (see features
programming table for options).
5. Sensor tests, adjustments, and protected entry tests are the same as for an RF Security System.
Arming defeat
1. Press the driver door lock switch.
2. The system does not arm if the Arm Defeat input wire is connected to the lock switch.
Disarming
1. Press the Unlock button on the OEM remote
2. Doors unlock, Lights flash and horn/siren sounds two times. If the system has been triggered, the horn/
siren sounds 4 times or 5 times if the sensor is bypassed
3. Dome light turns on, starter kill becomes inactive, and the status LED turns off.
•
If triggered, the status LED continues to flash to indicate triggered inputs (see table of zones). Turn
on the ignition to reset the LED.
Disarming defeat
1. Press the driver door unlock switch
2. The system does not disarm if the Disarm Defeat input wire is connected to either a passenger door
unlock motor wire or the driver door unlock switch.
Trunk release bypass while Armed
1. Press the Trunk release button on the OEM remote
2. Trunk opens
3. If the system is armed, the trunk shunt input causes the trunk input and sensor to be bypassed until the
trunk is closed.
Note: trunk release bypass requires the Gray/black trunk shunt input and Blue trunk trigger input to be con-
nected to the vehicle to bypass when armed (see Gray/Black wire description for wiring information).
Dealer Security
The following instructions assume the use of a dealer master remote control.
Arming
Passive
1. Turn the ignition off and close the doors, hood, and trunk.
2. The LED flashes quickly for 30 seconds.
•
An open door, trunk, or hood stops/resets the 30 second timer. If still open after 15 minutes the starter
kill becomes active.
3. The system arms as described when using a Dealer Master Remote.
Dealer Master Remote Operation
1. Press the
button.
2. Doors lock, Lights flash, starter kill becomes active, and the status LED begins flashing.
3. IF Security features are programmed on, the description under RF Security Arming is applicable.
A U X