Alemite 8424 Instrukcja serwisowa - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Przyrządy pomiarowe Alemite 8424. Alemite 8424 9 stron. Flow meter

Drukuj stronę

Flow Meter

9. NO OPERATION - The 8424 stores the

new work calibration factor and is ready

to begin dispensing, using the USER K

FACTOR that has just been calculated.

Meters Configuration

8424 features a menu with which the user can select

the main measurement unit, Quarts (Qts), Pints (Pts),

Liters (Lit), Gallons (Gal); The combination of the unit of

measurement of the Partial register and that of the Totals is

predefined according to the following table:

Unit of Measure

Combination

of the Partial

Liters (L)

Gallons (Gal)

Quarts (Qts)

Pints (Pts)

To choose between the 4 available combinations:

• Wait for 8424 to go to Standby,

• Press the CAL and RESET keys together. Keep these

pressed until the word "UNIT" appears on the screen

together with the unit of measurement set at that

time (in this example Liters/Liters

• Press the reset key to select the desired combination

of unit of measurement, amongst those shown below.

• Save the new combination by pressing the cal key at

length. 8424 will pass through the start cycle and

will then be ready to dispense in the set units.

WARNING

The Resettable Total and Total registers will be

automatically changed to the new unit of measure-

ment. NO new calibration is required after chang-

ing the Unit of Measurement.

Alemite, LLC

Maintenance

of maintenance. The only types of maintenance required

are the following:

1. Battery change – necessary when the batteries have

2. Cleaning of the turbine with washing or mechanically-

Battery Replacement

Measure of the

SIZE AAA. 8424 features two low-battery alarm levels:

Totals Register

1. When the battery charge falls below the first level on

Liters (L)

Gallons (Gal)

operate correctly, but the fixed icon

warns the user that it is ADVISABLE to

Gallons (Gal)

change the batteries.

2. If 8424 operation continues without

Do not discard the old batteries in the environ-

ment. Refer to local disposal regulations.

diagram positions, proceed as follows:

Total and the same Partial indicated before the batteries

8424 has been designed to require a minimum amount

run down.

handling.

8424 is complete with 2 x 1.5 V. alkaline batteries

the LCD, the fixed battery symbol appears.

In this condition, 8424 continues to

changing the batteries, the second

battery alarm level will be reached

which will prevent operation. In this condition the

battery icon starts to flash and is the only one to

remain visible on the LCD.

WARNING

To change the batteries, with reference to the exploded

• Press RESET to update all the totals

• Loosen the 4 screws securing the lower cover

• Remove the old batteries

• Place the new batteries in the same position as the

old ones

• Close the cover while positioning the rubber guard

as a gasket

• 8424 will switch on automatically and normal

operation can be resumed.

The 8424 will display the same Reset Total, the same

SER 8424

Revision (1-11)