Directed Electronics Viper Audio d300.1 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz samochodowy Directed Electronics Viper Audio d300.1. Directed Electronics Viper Audio d300.1 16 stron. Directed electronics audio d300.1 owners manual

Drukuj stronę

FRONT PANEL CONNECTIONS/CONTROLS

1. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass

through RCA jacks can be used to

send a signal to a second amplifier.

2. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level

outputs from head units or signal

processors at voltages between

150mV and 8 volts.

3. I I n n p p u u t t G G a a i i n n A A d d j j u u s s t t m m e e n n t t - Controls

amplifier sensitivity and is used to

match the input level of the ampli-

fier to the output level of the signal

source.

4. P P h h a a s s e e S S w w i i t t c c h h - Changes the phase

of the subwoofer speaker output by

180 degrees

5. C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t m m e e n n t t -

Adjusts the crossover point for the

on-board active crossovers.

FIGURE 1—AMPLIFIER CONNECTIONS d300.1 FRONT

6. B B a a s s s s E E Q Q S S w w i i t t c c h h - Adds an additional

eight db of boost to the subwoofer

output when on.

7. S S t t a a t t u u s s L L E E D D - Will light GREEN to indi-

cate the amplifier is on and oper-

ating normally, and will be off if the

amplifier shuts down due to short

circuit, or DC offset. The LED will

remain on and output will cease if

the amplifier overheats.

8. R R e e m m o o t t e e S S u u b b L L e e v v e e l l C C o o n n t t r r o o l l - Controls

the subwoofer amplifier gain

controls from a remote location for

ease of adjustment during listening.

W W a a r r n n i i n n g g : : DO NOT connect a level control knob from other

manufacturers to the Remote Sub Level Control of

any Viper amplifier. Even though the connectors fit

properly, the control knob and connector pin posi-

tions may be different and the amplifier will be

damaged.