Clarke 6470162 Instrukcja obsługi i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Piła Clarke 6470162. Clarke 6470162 17 stron. 355mm abrasive cut-off saw

ADJUSTMENTS

WARNING: TURN OFF AND UNPLUG THE SAW BEFORE MAKING ANY

ADJUSTMENTS. MAKE SURE THE TRIGGER SWITCH IS IN THE OFF POSITION.

CHANGING THE CUTTING ANGLE

1. Use the hex wrench provided to

loosen (do not remove) the two

fence bolts.

2. Adjust the fence to the desired

angle.

3. Re-tighten both fence bolts before

use.

• When making a mitre cut, the

vice may not clamp securely,

depending on the thickness of the workpiece and the mitre angle.

• Other aids (such as spring, bar or C-clamps) will be necessary to

secure the workpiece to the fence when making these cuts.

1. Disconnect the power supply.

2. Loosen the two fence bolts, push

the arm down until the cutting disc

lowers into the base.

3. Place a set square against the

cutting disc and adjust the fence to

rest against the square.

4. Securely tighten both fence bolts

before use.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]