Clarke 6470162 Інструкція з експлуатації та технічного обслуговування - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Пила. Clarke 6470162. Clarke 6470162 17 сторінок. 355mm abrasive cut-off saw
Друкувати сторінку
ADJUSTMENTS
WARNING: TURN OFF AND UNPLUG THE SAW BEFORE MAKING ANY
ADJUSTMENTS. MAKE SURE THE TRIGGER SWITCH IS IN THE OFF POSITION.
CHANGING THE CUTTING ANGLE
1. Use the hex wrench provided to
loosen (do not remove) the two
fence bolts.
2. Adjust the fence to the desired
angle.
3. Re-tighten both fence bolts before
use.
• When making a mitre cut, the
vice may not clamp securely,
depending on the thickness of the workpiece and the mitre angle.
• Other aids (such as spring, bar or C-clamps) will be necessary to
secure the workpiece to the fence when making these cuts.
SQUARING THE FENCE TO THE BLADE
1. Disconnect the power supply.
2. Loosen the two fence bolts, push
the arm down until the cutting disc
lowers into the base.
3. Place a set square against the
cutting disc and adjust the fence to
rest against the square.
4. Securely tighten both fence bolts
before use.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9