Clarke CMSF110 Instrukcja obsługi i konserwacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Piła Clarke CMSF110. Clarke CMSF110 20 stron. Multi purpose circular saw

OPERATION

STARTING A CUT

1. Place the leading edge of the sole plate on the top face of the

workpiece, ensuring the saw blade is NOT making contact.

2. Push IN and hold the trigger

safety button on the side of

handle to either the left or right

side. At the same time squeeze

the trigger and keep it depressed

to start the saw.

3. When the motor has reached

maximum speed, line up the

notch on the cutting line as

shown in fig 1. Then move the

saw slowly forward.

• There is a second notch in the

rear of the sole plate which also

aligns with the cutting blade.

4. Always cut in forward direction and feed the saw into the work firmly and

at a slow rate. Do not force the saw and keep it in a straight line while

cutting. Always use the saw by holding it firmly with both hands.

5. Be aware that dust or sparks will be emitted depending on the material

being cut, and suitable precautions should be taken to protect the

operator from airborne particles.

FINISHING THE CUT

1. Release the trigger and allow the saw blade to stop completely before

withdrawing the saw from the cut.

2. NEVER attempt to remove the saw with the blade rotating and NEVER

attempt to stop the blade by lateral pressure.

CONTROLLING THE SAW

Kickback can occur when the blade stalls suddenly and the saw is driven

back towards you. Blade stalling is caused by any action which pinches the

blade into the material being cut.

Kickback could cause you to lose control of the saw and could result in

personal injury. Release the trigger immediately if blade binds or stalls.

COMMON CAUSES OF KICKBACK

Twisting the blade while making cut.

Sawing with a dull, gummed up, or improperly set blade.

Fig 1