Nikon Eclipse Series Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Nikon Eclipse Series. Nikon Eclipse Series 21 stron. Teaching head/ multi teaching head

Drukuj stronę

Assembly for the dual-viewing (side-to-side) model

Assemble the system in the order of the numbers ([1] to [7]) in the figure below.

 Check that the serial numbers on the two components (main observer section and secondary observer section)

of the teaching head S-S are identical. (If the numbers are different, observation will be adversely affected. In

this case, please contact your dealer or nearest Nikon representative.)

 Adjust the height of the support stand so that the main observer section and the secondary observer section

are horizontal. This step is facilitated by first adjusting the support stand to an approximate height before

attaching the stand.

 When a pointer is going to be used, assemble the system so that the secondary observer will be positioned on

the right. If reversed, the pointer control section will be at the rear of the microscope.

[3]

Clamp for [3]

Pointer mounting surface

[2]

Clamp for [2]

Chapter 3

Assembly

[1]

[5]

Clamp for [5]

Main observer

section

Place

horizontally

Check that the

serial numbers of

the teaching head

S-S are the same.

[7]

Secondary

observer

section

[4]

Height adjustment clamp screw

Adjust to an approximate height

and readjust later.

Upper surface should

also be horizontal.

Clamp for [7]

[6]

Clamp for [6]