Dirty hand 100481 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Łuparka do drewna Dirty hand 100481. Dirty hand 100481 16 stron. 5-ton electric log splitter

Operating Instructions

Always split the log along the grain of the wood. Splitting across

the grain may cause some types of wood to burst or splinter

resulting in possible injury.

If a log becomes stuck on the wedge, remove both hands, unplug

the log splitter from the power source and knock the log off of

the wedge with a hammer. Do not attempt to dislodge the log

with your hands.

When finished splitting the logs, switch the motor off and

unplug the power cable.

DIRECTIONS FOR REPLACING HYDRAULIC FLUID

1) Place a large pan under the motor end of the log splitter.

2) Use the included hex wrench to loosen the fluid drain bolt and

remove the bolt with the attached dipstick.

3) Raise the motor end of the log splitter to allow the fluid to drain

in to a pan. Lower the splitter when it is empty. (See Fig A.)

4) Dispose of the used fluid properly.

5) Raise the splitting wedge end of the splitter and make sure it is

secure.

6) Pour approximately 3.2 liters of approved hydraulic fluid into

the tank.

7) Check the fluid level of the dipstick. Add more fluid if needed.

(See Fig B.)

8) Replace the fluid drain bolt and tighten securely.

9) Lower the log splitter.

Store the log splitter switched off and unplugged. Allow the log

splitter to cool for 5 minutes after use before storing. Protect

the power supply cable from heat, sunshine, aggressive liquids

and sharp edges. Store unit in a clean, dry area. Don't store it

unprotected outdoors, next to corrosive materials or in a damp

environment.

WARNING

Fig. A

Fig. B