Dirty hand 100481 Manual de operação - Página 14
Procurar online ou descarregar pdf Manual de operação para Cortador de lenha Dirty hand 100481. Dirty hand 100481 16 páginas. 5-ton electric log splitter
Imprimir página
Operating Instructions
Always split the log along the grain of the wood. Splitting across
the grain may cause some types of wood to burst or splinter
resulting in possible injury.
If a log becomes stuck on the wedge, remove both hands, unplug
the log splitter from the power source and knock the log off of
the wedge with a hammer. Do not attempt to dislodge the log
with your hands.
When finished splitting the logs, switch the motor off and
unplug the power cable.
DIRECTIONS FOR REPLACING HYDRAULIC FLUID
1) Place a large pan under the motor end of the log splitter.
2) Use the included hex wrench to loosen the fluid drain bolt and
remove the bolt with the attached dipstick.
3) Raise the motor end of the log splitter to allow the fluid to drain
in to a pan. Lower the splitter when it is empty. (See Fig A.)
4) Dispose of the used fluid properly.
5) Raise the splitting wedge end of the splitter and make sure it is
secure.
6) Pour approximately 3.2 liters of approved hydraulic fluid into
the tank.
7) Check the fluid level of the dipstick. Add more fluid if needed.
(See Fig B.)
8) Replace the fluid drain bolt and tighten securely.
9) Lower the log splitter.
STORAGE
Store the log splitter switched off and unplugged. Allow the log
splitter to cool for 5 minutes after use before storing. Protect
the power supply cable from heat, sunshine, aggressive liquids
and sharp edges. Store unit in a clean, dry area. Don't store it
unprotected outdoors, next to corrosive materials or in a damp
environment.
14
!
WARNING
Fig. A
Fig. B