Discount Car Stereo A2D-CDR30 Skrócona instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja instalacji dla Samochodowy system stereo Discount Car Stereo A2D-CDR30. Discount Car Stereo A2D-CDR30 5 stron. Musicstreaming for porsche cdr30/31 radios
Również dla Discount Car Stereo A2D-CDR30: Skrócona instrukcja instalacji (7 strony)

Drukuj stronę

Tap or connect Red Accessory wire to suitable 12V Accessory

supply source (e.g. fuse box etc.)

Some Suggestions include:

1. In 968, 981: Left footwell Fuse box at Row C, Fuse 1 (7.5A/15A)

2. In 987: Kick Panel Fuse box at Row B, Fuse 9 (7.5A)

3. Alternate: Remove hand-brake cover and locate orange wire. Tap into it

using supplied T-tap (See Fig. 4)

harness below brake lever

Warning:

Connecting red wire to constant (battery) supply is not

recommended. Always connect to an accessory supply wire. Use

voltmeter or test light to verify voltage on suggested accessory wires

and check for engine noise prior to finalizing install. In case of engine

noise we recommend adding a noise filter such as our

5. Securely adapter and proceed to next section

Fig. 4

NF3A

Pairing:

Pairing process varies among devices the but basic steps are the same. This

process is done upon initial install and will not have to be repeated.

Turn ignition and Radio "ON"

LED inside module will blink (pairing mode)

Settings, Wireless & Networks, Bluetooth

2. On A2DP device: go to

Settings

Bluetooth

3. Select

and turn on.

4. Select Bluetooth settings

Scan for devices

5. Tap

Wait for Bluetooth device name to appear and select it.

LED inside module peephole will glow steady (paired)

Note:

Pair multiple devices (10) but only one connection is supported.