Discount Car Stereo A2D-CDR30 빠른 시작 설치 매뉴얼 - 페이지 3

{카테고리_이름} Discount Car Stereo A2D-CDR30에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo A2D-CDR30 5 페이지. Musicstreaming for porsche cdr30/31 radios
Discount Car Stereo A2D-CDR30에 대해서도 마찬가지입니다: 빠른 시작 설치 매뉴얼 (7 페이지)

페이지 인쇄

Tap or connect Red Accessory wire to suitable 12V Accessory

supply source (e.g. fuse box etc.)

Some Suggestions include:

1. In 968, 981: Left footwell Fuse box at Row C, Fuse 1 (7.5A/15A)

2. In 987: Kick Panel Fuse box at Row B, Fuse 9 (7.5A)

3. Alternate: Remove hand-brake cover and locate orange wire. Tap into it

using supplied T-tap (See Fig. 4)

harness below brake lever

Warning:

Connecting red wire to constant (battery) supply is not

recommended. Always connect to an accessory supply wire. Use

voltmeter or test light to verify voltage on suggested accessory wires

and check for engine noise prior to finalizing install. In case of engine

noise we recommend adding a noise filter such as our

5. Securely adapter and proceed to next section

Fig. 4

NF3A

Pairing:

Pairing process varies among devices the but basic steps are the same. This

process is done upon initial install and will not have to be repeated.

Turn ignition and Radio "ON"

LED inside module will blink (pairing mode)

Settings, Wireless & Networks, Bluetooth

2. On A2DP device: go to

Settings

Bluetooth

3. Select

and turn on.

4. Select Bluetooth settings

Scan for devices

5. Tap

Wait for Bluetooth device name to appear and select it.

LED inside module peephole will glow steady (paired)

Note:

Pair multiple devices (10) but only one connection is supported.