DiscountRamps Apex ATR-RACK-V2 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stojaki i stojaki DiscountRamps Apex ATR-RACK-V2. DiscountRamps Apex ATR-RACK-V2 8 stron. 4 post aluminum truck rack

Drukuj stronę

STEP 3. Installation

① Attach an M10x75 Hex Head

Bolt (13), and M10 Hex Nut

(14), to each of the eight

C-Clamps (7), as shown.

Position C-Clamp (7), close to the

base of the support arm so that

the tongue on the upper jaw

engages the groove in the Leg

Rail Mount (3), or (4). Place a

Clamp Bolt Foot (8), on the end

of the M10x75 Hex Head Bolt

(13), as shown.

④ Continue the above procedure until you have installed two C-Clamps to each of the four Leg Rail

Mounts, securely affixing both crossbar assemblies to the truck bed rails as shown. WARNING! ALL

EIGHT C-CLAMPS MUST BE PROPERLY INSTALLED AS SHOWN FOR SAFE OPERATION OF THIS RACK.

Rev. 062118

② Tighten the M10x75 Hex

Head Bolt (13), and the M10

Hex Nut (14), until entire

assembly is firmly affixed to

the truck bed rail. Install a

second C-Clamp to the same

Leg Rail Mount at least 4"

from the first.

Position clamps at

least 4" apart

DiscountRamps.com • 1-888-651-3431

③ Put the eyebolt (23) through

the 10 spring washer (16)

and 10 flat washer (17),

screw the upper nut (18),

screw it for 2-3 turns and do

not tighten it. Insert it into

the lower groove of the cross

beam (1), put it in the

required position and then

tighten it.

Page 6