ARPEGE SECURITY TC-5500S Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Licznik gotówki ARPEGE SECURITY TC-5500S. ARPEGE SECURITY TC-5500S 10 stron. Vacuum banknote counter
Drukuj stronę Step 2: Re-press the ACC button after the counting mode selected. (The
lower part of LED display will show the number of "0" for starting the
counting processing.)
Step 3: The incorrect counting result will not be totaled if there is
problem in counting process. The CLEAR key can be used to delete the
last counting result if the user doesn't want it to be totaled.
※ The Self-Diagnosis Test Function
Function: This function is designed for checking the system's: 1)
Vacuum Pressure, 2) LED display, 3) Spindle Sets, 4) Counter
Sets, 5) Motors banknote counting and feeding process.
Step 1: User need to block the holes of Spindle Sets by adhesive plastic
tape and select 0 function key after the machine is power-on. The
Self-Diagnosis Test will operate automatically. User can press the
same key again to turn off this function.
Step 2: During testing mode, user can check the following five parts:
1) The Vacuum Pressure: The air pressure under counting cannot be
lesser than 480 cm/Hg. If it is lesser than this, then the machine
might not count the notes properly because of insufficient pressure.
User needs to check the vacuum system, including Vacuum Pump,
Pipe System and Filters. Most of time the operator just needs to
clean the filters of Pump (E007 / E008) and Suction Head (A002)
only.
2) The LED Display: If the numbers from 1-999 cannot be showed
properly on the screen, then please replace it with a new display.
3) The Spindle Set: It is driven by the motors to supply the vacuum
suction for banknote counting.
4) The Counter Set: User needs to block the holes on Spindle Set with
adhesive plastic tape. Then if the numbers from 1 to 999 are
displayed on the screen, it means Counter Set work properly.
5) The Motors: Checking Motor1 is to make sure the banknote gripper
is working properly; Checking Motor 2 is to make sure the spindle
set is driven by the motor properly.
Caution:
Test Mode is effective only after the machine is just power-On. You should re-start
the machine again if you need to use the Test Mode after any counting.