disperator 8075 Instrukcja instalacji, użytkowania i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji, użytkowania i konserwacji dla Zgniatarka do śmieci disperator 8075. disperator 8075 13 stron. Waste compactor
Drukuj stronęg) The compactor motor has an automatic thermal
cutout. If compactor is run repeatedly, this
protector may have opened the circuit. Wait a few
minutes and the cutout will reset automatically.
h) The waste container must be at least half
full of waste before any appreciable amount of
compacting will be apparent – as the compaction
plate does not travel all the way to the bottom
of the container. Waste in the bottom 1/3 of the
container will be compacted during subsequent
compacting.
i) On rare occasions, for example a large can
placed near the outer edge of the waste container
may become wrapped around the edge of the
ram (compaction plate). This could interfere with
proper compaction plate operation. To correct this
– open the front door – unlatch and open the front
of the waste container – and remove the can. Be
careful when handling sharp objects.
j) Is the interlock actuator (on the inside of the
compactor front door, see picture on front page
of this document) in good condition? If broken /
damaged – the compactor will not operate. Order
a spare interlock actuator from Disperator Co.,
and do not attempt to operate the compactor in
any other manner.
k) To obtain service and spare parts, inform
Disperator Co. about compactor model number,
serial number and nature of any defect in the
product or part. These data and other applicable
data is shown on the serial number plate located
on the inside cabinet wall.
4.3 Factory Guarantee
12 months in operative service but a maximum
of 18 months after delivery from Disperator.
10