disperator 8075 Instrukcja instalacji, użytkowania i konserwacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji, użytkowania i konserwacji dla Zgniatarka do śmieci disperator 8075. disperator 8075 13 stron. Waste compactor

Drukuj stronę

The compaction plate is cleaned as follows:

a) Remove possible waste bag from container

(see item 3.3 above).

b) Push the waste container into the cabinet.

Unlatch and lower the container front.

c) Press the compaction plate release tab on

the front of the ram to disengage the plate (see

picture below). The plate can be removed by

pulling down and away from the ram.

d) Once removed the compaction plate can be

washed in a mild detergent solution.

e) Reinstall the compaction plate by inserting the

tab (on the rear of the plate) into the slot (in the

rear of the ram). Press up on the front of the plate

until it securely latches in place.

RAM

RELEASE

TAB

COMPACTION

PLATE

The compaction ram is cleaned as follows:

a) Make sure the trash bucket (waste container) is

empty and pushed into the cabinet.

b) Turn the key lock swith to "ON" position, and

select the "HOLD" compact mode. See picture on

front page of this document.

c) Close the door and press the start button. The

compaction plate will travel downward into the

trash bucket (waste container) and stop at the

bottom of its stroke (see picture below).

TRASH

BUCKET

RAM

CAUTION: Sharp waste pieces may be on or

around the surfaces to be cleaned. Carefully

remove these objects before wiping down any

surfaces.

d) Open the door. Unlatch and lower the front of

the trash bucket (waste container). Vaccum top

of compaction plate (ram) and clean with a mild

detergent solution.

e) When finished cleaning – raise and re-latch

trash bucket (waste container) front – close

the door – and press the start button. The

compaction plate will return to the top position,

and automatically stop. Open the door, slide

waste container out, install waste bag and select

compact mode. The compactor is now ready to

receive waste.

4.2 Troubleshooting

a) Is electric cord on the back of the compactor

plugged in securely?

b) Has a wall fuse blown / a circuit breaker

tripped?

c) Is the front door firmly closed?

d) Is the key switch in the "ON"-position?

e) Is the start button pressed long enough to start

the compaction cycle?

f) If waste container is difficult to close, check to

see if any waste has fallen behind the container,

preventing it from closing completely.